Many of the primitive data types in coherence supports configuration to make it possible to optimize the data being sent over the network. These settings can be made individually for each field of a component and will then be used throughout your code base.
The field settings uses the meta data syntax in the schema, which looks like this:
The meta data always goes at the end of the line and can be set on both definitions and the fields within a definition, like this:
In this example, a component named Health would be created, but instead of using the default 24 bits when sending its value, it would just use 8. Any updates to it would also be deprioritized compared to other components, so it could potentially be sent a bit late if bandwidth is scarse.
Component updates do not only contain the actual data of the update, but also information about what entity should be affected, etc. This means that the total saving of data won't be quite as large as you'd think when going from 24 to 8 bits. Still, it's a great improvement!
All components support a piece of meta data that affects how highly the Replication Server will prioritize sending out updates for that particular component.
This meta data is set on components, like this:
The available priority levels are:
"very-low"
"low"
"mid" (default)
"high"
"very-high"
Some of the primitive types support optimizing the number of bits used to encode them when sending the over the network. It's worthwhile to think through if you can get away with less information than the default, to make room for more frequent updates.
All of these types support the same two settings:
bits – how many bits the type should use to encode its floating point values
scale – the maximum and minimum value of each of its scalars (a scale of
Integers can be configured to only hold a certain range via:
range-min – the lowest possible value that the integer can hold
range-max – the largets possible value that the integer can hold
Using these settings you can emulate other numeric types like char, short, unsigned int, etc.
Right now quaternions don't have any settings, but this will be remedied soon.
The other types doesn't have any settings that affect the number of bits they use. If they take up to much bandwith you'll have to try to send them less often, using priority, update frequency, or LODing.